AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Backup camera wiring12/20/2023 ![]() While at it, ensure you pay attention to/follow the manufacturer’s instructions. Mount the cameraĪttach the camera to your vehicle’s license plate. You may choose to close the trunk during this period. Once you have installed the monitor and the necessary backup camera cables or cords successfully, return to the drilled hole at the back of your vehicle.Ĭonnect the camera to its power and video cable. Don’t forget to hold them in position (stable and firm) using electrical tape.Īfterward, have the monitor’s power cable attached to a fuse tap, and then connect it into the fuse box. ![]() Once the splitter cable has been routed successfully, connect both ends of the Camera and RCA cables. Ensure the monitor’s camera and RCA cables are connected Route the monitor’s splitter cables accordingly.įrom the monitor, route the splitter cable through the space that is next to the fuse box. Ensure you mount the monitor according to the manufacturer’s instructions. Then, install your choice of the monitor (internal or external). Install your monitorĮxtend the backup video cable to the vehicle’s front. Afterward, have them coiled or twisted together. Positive cables should be connected, like the negative wires. Connect the camera wires with the park light cables Before you engage in this task, ensure your car’s engine is not running. This hole is made to separate the wire, thereby creating two strands. Afterward, create a hole at the center of each exposed wire. You can use a plier or stripper to peel off the rubber coating or insulation covering the wires. Strip the park light wires and separate them This is one of the easiest techniques out there. This way, whenever you need the reverse camera, all you need to do is activate the park light’s switch. In that case, you may consider connecting the camera to the park light. Suppose you desire a button or switch to activate the backup camera at will. Normally, a backup camera is connected to the reverse light cables. ![]() Pass the cable from the outside of your vehicle to the inside. Pass the camera cable into the trunkĮxtend the splitting end of the backup camera’s power and video cable into the trunk through the drilled hole. ![]() The main function of this material is to hold the cable in place. First, you need to insert a rubber grommet into the hole and ensure it fits it perfectly. Insert a grommet inside the drilled holeĭo not run or pass the camera cable directly inside the drilled hole. Ensure the drilled hole is not too small and can easily accommodate your backup camera’s cables. Drill a small hole through the license plate mounting spaceĭrill a small hole using a power drill. Once the panel is taken off, the rear wiring chambers become evident. Use a trim removal tool to take off the interior panel. Once the license plate has been detached successfully, take it off and store it safely. Take out the screws holding the license plate together using a screwdriver. In some cases, your backup camera and monitor may not come with the RCA video cable, camera and monitor splitter cords, and video and power cable connectors. With the right tools, you can remove/detach your vehicle’s parts and components efficiently and effectively, thereby ensuring an effortless installation.Įnsure you have the necessary cords/cables
0 Comments
Read More
Leave a Reply. |